The highly elastic universal sealing compound is resistant to all mineral oils, a wide range of synthetic oils, lubricants, petrol and diesel fuels, as well as grease, cold and hot water, cleaning agents, sunlight, ozone, and sea water. REINZOSIL-t is suitable for continuous operation in the temperature range between -50 °C and +180 °C. Hardness (softness) lies in the range of 20 to 25 Shore A Application Due to its particular characteristics, REINZOSIL-t is used in the most varied applications, e.g. as FIPG (formed-in-place gasket) for wet assembly, i.e. for sealing small gaps under pressure, as well as for cylinder liners in piston machines, and also to compensate for extensive component warping. Moreover, the compound is also used to seal constructional fissures or cracks, and for seals that are subjected to considerable relative movement.

Contrary to REINZOPLAST, the sealing film is destroyed during disassembly, and a new coating is required after the surfaces have been cleaned. The compound can also be applied to assembled components. In these cases, and after the sealing joint has been cleaned and degreased, REINZOSIL-t is applied directly to the sealing gap, similar to the procedures used in the building industry.

Remove any gasket remnants or other residues such as grease, oil, etc. with RE-MOVE solvent remover. Allow the surfaces to dry, then apply the sealing compound on one side manually or by means of a pneumatic spraying device. Assemble the components immediately.

Processing temperature lies between +5°C and +40 °C. Depending on temperature and humidity, a skin develops after about 10 minutes. The full curing time depends mainly on the relative air humidity (RH) and room temperature, as well as on the thickness (gap height) and width of the applied layer.